AMD FirePro R5000 Betriebsanweisung PDF herunterladen (Seite 23)

5.2 Wake-on-LAN (WOL) Configuration

There are two ways to configure WOL:

1. If your motherboard supports PCI_WAKE# signal (check with your motherboard

supplier to see if this is supported):

Note: This method is considered standard WOL, using an external signal.

•

If required, configure the system BIOS to enable “power on by PCIe

devices.”

2. If your motherboard does not support PCI_WAKE# signal:

Note: This method wakes the system through the R5000, without an external

signal.

•

To send the WOL signal: connect J6703 to PWR_SW pins on the motherboard

(power cable not included).

•

If your motherboard does not support a common ground on the PWR_SW

pins, short pins 2-3 on J6701; otherwise connect pins 1-2.

Figure 5–3 Wake-on-LAN

5.3 Full Reset

To do a full reset on the board:

1. Short pin 2-3 on J6803.

2. Power on and boot the system.

3. Shut down the system and remove the jumper.

Remote Graphics 17

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 35 36

Keine Kommentare

AMD FirePro R5000 Betriebsanweisung Seite 23