AMD LE-363 User's Betriebsanweisung PDF herunterladen (Seite 407)

100

101

Chapter 20 Upgrading XgOS 381

Upgrading Windows Host Servers

When using vNICs in an HA configuration, system .DLL files are in use. This

prevents the upgrade process from accessing the .DLL files needed for upgrade. To

upgrade the Windows host drivers from 3.5.0 to 3.6.0 using HA vNICs, it is best if

you first uninstall the previous version of host drivers, restart your Windows host,

and then proceed with a clean installation of the Windows host drivers. Follow the

instructions in the Fabric Interconnect Hardware and Drivers Installation Guide.

▼ Upgrading Windows Host Servers

In release 3.6.0, host driver upgrade is not supported. Instead, uninstall the old

drivers and then install the new ones as follows:

1. Log in to the Windows server as administrator.

2. Get the updated Xsigo software.

Either download the software from the support site or put the CD into the drive.

3. Extract the software archive to any directory.

Note – Be sure to completely extract the software to a folder. Do not attempt to

install the drivers from a compressed folder.

4. Open a command prompt by clicking Start>Run> and entering cmd.

5. Change directory to the location of your existing Xsigo software.

For example: cd D:\xsigo

6. Run the setup.exe and follow the instructions for removing the Xsigo host

drivers.

7. Reboot the server.

8. Change directory to the location of your 3.6.0 system software

9. Run the setup.exe and follow the instructions for installing the new Xsigo host

drivers.

10. If this server supports services that depend on storage that is accessed across

vHBAs, configure dependencies for those services by issuing the following

command:

sc config <serviceName> depend= xgdependroot

1 2 ... 402 403 404 405 406 407 408 409 410 411 412 ... 435 436

Kommentare zu diesen Handbüchern

Keine Kommentare

AMD LE-363 User's Betriebsanweisung Seite 407

Kommentare zu diesen Handbüchern